The maintenance of Dacromet Coating Equipment

The maintenance of Dacromet Coating Equipment

Dacromet coating equipment need regular maintenance to make the recovery of equipment performance and prolong service life. The content of maintenance including cleaning the equipment, keeping the tidy of equipment and good lubrication, tighten the loose fasteners in time, adjusting the clearance of moving parts and guaranteeing the safe operation of Dacromet coating equipment.

Maintenance matters needing attention are as follows:

1. To ensure the power is off before execution. If it is must be working under the charge state, operation should be very careful.

2. Electrical wiring work must be operated by a qualified electrical engineer.

3. Sending warning to staff clearly when the equipment is undergoing maintenance. The equipment can not be operated.

4. To ensure the powder is off before executing of maintenance and examination for electrical control cabinet and electrical engine. Note: When the main power switch off, the components may residual battery, so before the steps of maintenance, please use multimeter to ensure the components without the residual battery.If the power is supplying when performing the maintenance, it must be performed by a qualified electrical engineer.

5. Unless you perform maintenance and inspection procedures, please do not open the electric control cabinet.

6. Checking whether the threaded parts firm tightly or not, do not over tighten the bolts.

7. If the dacromet coating liquid impregnation tank without using for a long time. We should clean filtering circulation system to avoid pipeline jam. If we do not use it, we need to use special liquid diluent washing recycle pump to avoid using liquid condensation dry in recycling pump.

Dacromet coating liquid is more sensitive to temperature requirements, to prevent aging and layered of coating fluid, the refrigeration and heating equipment of industrial cold water machine and the pneumatic device of semi-automatic coating machine should be guaranteed in normal working condition.

The services lif of dacromet coating equipment to a large extent depend on equipment maintenance and whether the maintenance work is done.”Cleaning, lubrication, fastening, adjustment, anti-corrision”, this is the law of equipment maintenance.